Planet Networking & Communication IMG-120T User Manual page 33

User's Manual of IMG-120T
Manual Add Device
This option allows you to manually set up IP search device and send search unicast packets; there are two ways
to manually add the device as shown below:
1: Add "On line Devices" under an existing IP address, click "√" in front of the desired IP address and click on
">" to add IP address;
2: A "Device IP Address" is filled out to manually enter the IP address and click "Add" to add the IP address.
Click OK for adding a unicast packet to search equipment. If the router's port mapping is configured, it can
implement search across route. Discovery process begins from PC Port 65533, Port 65534 sends commands to
the specified device, and then Port 65533 responds to a search and send confirmation to PC Port 65534 to
complete the search.
Figure 3-27: Planet Modbus Gateway Utility Tool Bar -- Manual Add Device Screen
Batch IP Settings
This option allows you to set up IP addresses for a group of devices so as to avoid one-by-one setting, which can
save a lot of time.
-33-