Hardware Dip Switch For Reset To Default - Planet Networking & Communication IMG-120T User Manual

2.1.5 Hardware DIP Switch for Reset to Default

The upper panel of the Industrial Modbus Gateway consists one 4-bit DIP switch for resetting the system to the
factory default mode.
■ Resetting to default through hardware DIP switch:
1: Find the hardware DIP switch that is near the RJ45 port of the Industrial Modbus Gateway.
2: Adjust DIP 2 at the "ON" position and DIPs 1, 3, 4 remain at the original position.
3: After adjusting the DIP switch, please power off and power on the Industrial Modbus Gateway to
take effect.
After resetting the Industrial Modbus Gateway with the default IP address, and username
and password: admin, please adjust DIP 2 to lower position. Otherwise, the Industrial
Modbus Gateway will continue to reset to the factory default mode.
-16-
User's Manual of IMG-120T