Starting The Engine (Vehicle Without Keyless Push Start System); Starting The Engine - Suzuki SX4 2016 Owner's Manual

Clutch Pedal (1)
(For manual transaxle)
The clutch pedal is used to disengage the
drive to the wheels when starting the
engine, stopping, or shifting the gearshift
lever. Depressing the pedal disengages
the clutch.
WARNING
Do not drive with your foot resting on
the clutch pedal. It could result in
excessive clutch wear, clutch dam-
age, or unexpected loss of engine
braking.
Brake Pedal (2)
Your SUZUKI vehicle is equipped with front
and rear disc brakes. Depressing the
brake pedal applies both sets of brakes.
You may hear occasional brake squeal
when you apply the brakes. This is a nor-
mal condition caused by environmental
factors such as cold, wet, snow, etc.
WARNING
If brake squeal is excessive and
occurs each time the brakes are
applied, you should have the brakes
checked by your SUZUKI dealer.
WARNING
Do not "ride" the brakes by applying
them continuously or resting your
foot on the pedal. This will result in
overheating of the brakes which
could cause unpredictable braking
action, longer stopping distances, or
permanent brake damage.
Accelerator Pedal (3)
This pedal controls the speed of the
engine. Depressing the accelerator pedal
increases power output and speed.
OPERATING YOUR VEHICLE

Starting the Engine

(Vehicle without Keyless
Push Start System)
Before Starting the Engine
MT
AT
1) Make sure the parking brake is set fully.
2) Manual transaxle – Shift into "N" (Neu-
tral) and depress the clutch pedal all
the way to the floor. Hold the clutch
pedal while starting the engine.
Automatic transaxle – If the gearshift
lever is not in "P" (Park) position, shift
into "P" (Park). (If you need to re-start
the engine while the vehicle is moving,
shift into "N".)
83RM0-01E
83RM005
3-12