Suzuki SX4 2016 Owner's Manual page 118

4WD Warning Light (if equipped)
57L30042
When you press the engine switch to
change the ignition mode to "ON", the light
comes on briefly so you can check that the
light is working.
• This light comes on if there is any prob-
lem with the four-mode 4WD system.
The system will be deactivated automati-
cally.
• The light blinks if the vehicle is in either
of the following conditions, and the sys-
tem will be deactivated automatically.
– Wheels of different diameters are fitted
to the vehicle.
– Drive train components overheat as a
result of spinning of a drive wheel in
the mud or snow.
NOTE:
Should the light blink, immediately move
the vehicle to a safe place and park it there
to protect the drive train components. If
you let the engine run at idle for a while
except for the case of different sized
wheels are fitted, the light will go out and
the system will resume.
Oil Change Request Light
(if equipped)
Your vehicle has the oil life monitoring sys-
tem and related Oil Change Request Light
that alerts you to change the engine oil and
filter.
This light comes on for several seconds
when the ignition switch is turned to the
"ON" position or the engine switch is
pressed to change the ignition mode to
"ON" so you can check that light is working.
(For gasoline engine models)
When this light blinks, change engine oil
and oil filter immediately. For details on
how to change the engine oil and oil filter,
refer to "Changing Engine Oil and Filter" in
the "INSPECTION AND MAINTENANCE"
section.
If either of odometer reading or time is
reached to the value which is set by the
system, this light blinks when the ignition
switch is in the "ON" position or the engine
switch is pressed to change the ignition
mode to "ON". In addition, the message is
shown on the information display to tell
BEFORE DRIVING
you it is necessary to change the engine oil
and oil filter. When the engine oil and oil fil-
ter are changed, and the oil life monitoring
system is reset, this light will go out.
Whenever the engine oil is changed, the
light must be reset to monitor the next oil
change timing properly. The light will go
out after the reset. For the resetting proce-
dure, refer to "Information Display" in this
section.
79JM007
NOTICE
Severe engine damage will result, if
you keep operating the engine after
this light blinking.
Change the engine oil and filter
immediately when the light blinks.
NOTE:
This light is used to facilitate the oil and oil
filter change according to the maintenance
schedule.
(For diesel engine models)
If this light blinks when the engine is run-
ning, you should change the engine oil and
oil filter immediately since the monitoring
system has calculated that oil life has been
diminished by a deterioration of engine oil.
When the engine oil and oil filter are
changed, and the oil life monitoring system
is reset, this light will go out. For details on
how to change the engine oil, refer to
"Changing Engine Oil and Filter" in
"INSPECTION AND MAINTENANCE" sec-
tion.
2-94
83RM0-01E