Suzuki SX4 2016 Owner's Manual page 368

WARNING
(Continued)
To minimize your exposure to used
oil, wear a long-sleeve shirt and
moisture-proof gloves (such as dish-
washing gloves) when changing oil. If
oil contacts your skin, wash thor-
oughly with soap and water.
Launder any clothing or rags if wet
with oil.
Recycle or properly dispose of used
oil and filters.
5) Reinstall the drain plug with new gas-
ket. Tighten the plug with a wrench to
the specified torque.
NOTE:
(For Gasoline Engine Model with oil
change request light)
• Whenever the engine oil is changed, the
oil life monitoring must be reset to moni-
tor the next oil change timing properly
whether the oil change request light
blinks or not. To reset the oil change
request light, consult your SUZUKI
dealer. If you reset it by yourself, refer to
"Setting Mode" in "Information Display"
in the "BEFORE DRIVING" section.
• For more information of the oil change
request light, refer to "Oil Change
Request Light" in the "BEFORE DRIV-
ING" section.
NOTE:
(For Diesel Engine Model)
• Whenever the engine oil is changed, the
oil life monitoring must be reset to moni-
tor the next oil change timing properly
whether the oil change request light
blinks or not and whatever the remaining
distance of oil life on the information dis-
play shows. To reset the oil life monitor-
ing, consult your SUZUKI dealer.
• For more information of the oil change
request light and oil life monitoring, refer
to "Oil Change Request Light" and "Infor-
mation Display" in the "BEFORE DRIV-
ING" section.
INSPECTION AND MAINTENANCE
Replace the Oil Filter
NOTE:
(For Diesel Engine Model)
Since special procedures and tools are
required, it is recommended that you trust
this job to your authorized SUZUKI dealer.
1) Using an oil filter wrench, turn the oil fil-
ter counterclockwise and remove it.
2) Using a clean rag, wipe off the mount-
ing surface on the engine where the
new filter will be seated.
3) Smear a little engine oil around the rub-
ber gasket of the new oil filter.
4) Screw on the new filter by hand until the
filter gasket contacts the mounting sur-
face.
83RM0-01E
7-28