Suzuki SX4 2016 Owner's Manual page 147

OPERATING YOUR VEHICLE
"Remote Controller Outside" Warn-
ing
When either of the conditions described
below is met, the system issues a "remote
controller outside" warning by sounding the
interior and exterior buzzers. At the same
time, the immobilizer/keyless push start
system warning light comes on and the
master warning indicator light blinks.
• Any door is opened and then closed
while the remote controller is not inside
the vehicle and the engine is running or
the ignition mode has been changed to
"ACC" or "ON" by pressing the engine
switch.
• The remote controller is not inside the
vehicle when you attempt to start the
engine after changing the ignition mode
to "ACC" or "ON" by pressing the engine
switch.
3-9
(2)
(1)
(1) Immobilizer/keyless push start sys-
tem warning light (blinks)
(2) Master warning indicator light (blinks)
NOTE:
• If the warning is given, locate the remote
controller as soon as possible.
• Any attempt to start the engine will fail
while the warning is active. The mes-
sage appearing on the information dis-
play in the instrument cluster will also
indicate this condition. Refer to "Informa-
tion display" in the "BEFORE DRIVING"
section for details.
• Normally, the immobilizer/keyless push
start system warning light should go out
and the master warning indicator light
should stop blinking shortly after the
remote controller is brought back inside
the vehicle. If they remain lit and blink-
ing, change the ignition mode to "LOCK"
(OFF) by pressing the engine switch and
then perform the engine starting opera-
tion. Refer to "Starting the Engine" in this
section.
• Always keep the remote controller with
you as the driver.
Interior Workable Area for Engine
Starting, Ignition Mode Selection
and "Remote Controller Outside"
Warning
83RM045
(1) Interior workable area
The "interior workable area" for these func-
tions is defined as all the interior spaces
except for the space above the instrument
panel.
(1)
61MM0B002
83RM0-01E