Table of Contents
Advertisement
Installation – see figure
•
Remove either end cover by removing the four screws.
•
The clips shown indicate the two orientations available for mounting.
•
Select the orientation required, a pair of clips is used for each (AX or AY).
•
Slide nuts (B) into the appropriate slots.
•
Replace the end cover.
•
Screws (C) are passed through mounting clips (A) and into slot nuts (B).
•
Position the loose assemblies as required and tighten the screws.
DIN Rail Mounting Kit for NL Range
Pack Contents
Description
Mounting Clip
M3 Nut
M3x8mm Countersunk screw
NL-200 Series Controller User Manual
Addendum
Drawing Ref
Quantity
A
B
C
2
2
2
A
Advertisement
Table of Contents
