Table of Contents
Advertisement
8.12
Viewing Trigger Status
When a channel is in pulse mode, it is possible to view the trigger input status and whether the light
is pulsing. To enter this mode, press and hold SEL for 1 second. Then use UP/DOWN to select "trg"
then press SEL. The display below will be shown. Press SEL to cancel this display.
8.13
View Output Current
An approximate measure of the output current can be viewed from the keypad. The current is up-
dated approximately every second, but can be slower for pulse mode.
NL-200 Series Controller User Manual
Front Panel Configuration
(NL-200, NL-220, NL-220F)
8-9
Advertisement
Table of Contents
