CAUTION
Risk of possible damage to instrument. Unpacking the LS 13 320 without full
installation knowledge of the instrument could result in damage or not properly
identifying damage during shipment. Do NOT unpack the instrument. An
authorized Beckman Coulter Service Representative is responsible for unpacking,
installing, and setting the instrument for you.
Each LS 13 320 is tested before shipping. International symbols and special handling instructions
are printed on the shipping cartons to inform the carrier of the precautions and care applicable to
electronic instruments.
Installation Requirements
Environment
For best performance of the LS 13 320, find a site that is:
• Clean and free of dust
• Well ventilated
• Smoke free
• Isolated from external vibration sources
• Temperature controlled as large or frequent variations in temperature can change the
alignment of the laser beam
The system requires a flat, stable surface at least 0.7 m (2.5 ft) wide and 1.8 m (6 ft) in length. A height
clearance of at least 0.7 m (2.5 ft) is recommended.
Power Requirements
CAUTION
If you plan to use a power strip other than one recommended by Beckman Coulter,
please call your local Beckman Coulter representative to be sure that your power
strip is compatible with your instrument.
Make sure the instrument is close enough to a power receptacle so that the AC power cable reaches
it without stress. Power requirements are shown in
requirement labels located in the rear lower right corner of the bench.
PN B05577AC
Installation
Table 2.1
and
Figure 2.1
shows the electrical
CHAPTER 2
2-1