Ringing Characteristics; Software Specifications - Cisco ATA 190 Administration Manual

Appendix A ATA 190 Specifications

Ringing Characteristics

Table A-5
Description
Tip/ring interfaces for each RJ-11 FXS port (SLIC)
Ring voltage
Ring frequency
Ring waveform
Ring load
Ringer equivalence number (REN)
Loop impedance
On-hook/off-hook characteristics
On-hook voltage (tip/ring)
Off-hook current
RJ-11 FXS port terminating impedance option

Software Specifications

Table A-6
Description
Call progress tones
Dual-tone multifrequency (DTMF)
Fax
OL-31821-02
Ringing Characteristics
Software Specifications (All Protocols)
Specification
Configurable for two sets of frequencies and single set of on/off
cadence
DTMF tone detection and generation
Fax pass-through and T.38 fax relay mode.
V34 fax is supported for pass-through mode. Success of fax
transmissions up to 33.6 kb/s depends on network conditions,
and fax modem/fax machine tolerance to those conditions. The
network must have reasonably low network jitter, network delay,
and packet-loss rate.
Cisco ATA 190 Analog Telephone Adapter Administration Guide for SIP (Version 1.1)
Specification
70V (typical, balanced ringing only)
RMS
20 Hz
Trapezoidal with 1.2 to 1.6 crest factor
1400 ohm + 40μF
Up to 5 REN per RJ-11 FXS port
Up to 200 ohms (plus 430-ohm maximum phone DC
resistance)
–47V
24 mA (nominal)
The ATA 190-I1 provides multiple impedance, such
as 600 ohm for American SKU, 900 ohm for
European SKU, 220 ohm (820 ohm || 120nF) for
Australian SKU, and so on.
Ringing Characteristics
A-3