Install The Ata 190; Attach A Phone To The Ata 190; Verify The Ata 190 Startup Process - Cisco ATA 190 Administration Manual

Chapter 3 ATA 190 Installation

Install the ATA 190

To install an ATA 190, follow these steps:
Procedure
Connect the power supply to the Cisco DC Adapter port.
Step 1
Connect a straight-through Ethernet cable from the network to the network port on the ATA 190. Each
Step 2
ATA 190 ships with one Ethernet cable in the box.
You can use either Category 3/5/5e/6 cabling for 10-Mbps connections, but you must use Category
Note
5/5e/6 for 100-Mbps connections.

Attach a Phone to the ATA 190

You can attach one or two phones to an ATA 190 by connecting them to a phone port of the ATA 190
with an RJ11 cable. The ATA 190 PHONE1 and PHONE2 LEDs light as solid green when there is
activity on that port.

Verify the ATA 190 Startup Process

After the ATA 190 has power connected to it, it begins its startup process by cycling through these steps:
1.
2.
3.
4.
5.
If the ATA 190 flash memory is erased or the load is corrupted, the ATA enters a recovery mode where
it can restore the image by manual upgrading.
When you go offhook on the phone, you see the phone LED begin to flash, and you hear dial tone. The
ATA 190 has completed the startup process.
OL-31821-02
The Power LED is on.
The Network LED is flashing (when there is data traffic on Network port connected to a WAN port).
The ATA 190 is launching its application in this step.
Network LED is on.
After the Phone1 and Phone2 register with Cisco Unified CM successfully, the corresponding LEDs
are on.
All the LEDs are on.
Cisco ATA 190 Analog Telephone Adapter Administration Guide for SIP (Version 1.1)
Install the ATA 190
3-3