Fisher & Paykel OR90SCG1X User Manual page 57

PROBLEM
COOKTOP BURNERS
Some burners will not
light.
Flames do not burn all
around the burner
cap.
There is no clicking
when I try to light a
burner.
There is a power failure
– can I still use the
cooktop burners?
The flames have
suddenly gone out.
There is a slight
'extinction pop' or
flash after I've turned a
cooktop burner off.
The burner flames are
uneven, very large,
yellow or yellow-tipped
or sooty.
TROUBLESHOOTING
POSSIBLE CAUSES
Burner parts or ignitors
may be wet, dirty, or
misaligned.
The ignitor is dirty or
there is a power outage.
Power outage in your
area.
A draft or a spill has
extinguished the flame.
Technical fault: the gas is
the wrong type or hasn't
been adjusted properly.
WHAT TO DO
Check that the burner parts
are clean, dry, and correctly
assembled. Check that the
ignitors are clean and dry.
See 'Care and cleaning' for
instructions.
Clean the ignitor(s). See 'Care
and cleaning' for instructions.
You can still use your cooktop,
but will need to matchlight the
burner(s).
To do so, press in and turn the
dial anticlockwise to Hi while
holding a lighted match close to
the side of the burner. Keep the
dial held down for a few seconds
after the burner has lit, then
release. Wait until the flame is
burning evenly before adjusting
it.
IMPORTANT!
If the flame is blown out during
a power failure, turn the knob
immediately to O (OFF).
The flame failure protection will
automatically cut the gas supply
to the burner off, stopping
unburnt gas from escaping.
Turn the affected burner off, then
wait for at least 1 minute before
attempting to relight. This is to
allow for any small amount of
gas that may have escaped to
disperse.
This is normal and requires no
action.
Do not use your cooktop
burners. Contact your Authorised
Service Center or
Customer Care.
55