Replacing The Burner Parts - Fisher & Paykel OR90SCG1X User Manual

Burner parts and trivets
You can remove and clean these parts with hot soapy water or non-abrasive detergents.
●
Clean spills regularly before they become burnt on. Do not wash these parts in a
●
dishwasher.
After cleaning, check that the burners and their flame spreaders are dry before replacing
●
correctly.
It is very important to check that the burner flame spreader and the cap have been
●
correctly positioned. Failure to do so can cause serious problems.
Check that the ignitor is always clean to ensure trouble free sparking. It must be cleaned
●
very carefully using a toothbrush and methylated spirits.
To avoid damage to the electronic ignition, do not try to light a burner without all burner
●
parts in place.

Replacing the burner parts

Carefully replace the burner parts as per the following illustrations.
●
Fit the flame spreader to the housing as shown below. Make sure the burner is not able
●
to rotate.
Check that:
the ignitor is always clean to ensure trouble-free sparking.
●
the probe is always clean to ensure correct operation of the safety valves.
●
the flame spreaders are clean and the holes are not clogged.
●
Both the ignitor and probe must be very carefully cleaned using a toothbrush and
●
methylated spirits.
Replacing the semi-rapid, rapid and auxiliary burners
C
Cap
Flame
F
spreader
Flame
T
failure
probe
Correct positioning of burner parts
CARE AND CLEANING
S
Ignitor
Replacing the burner caps
49