ABB Relion 670 series Engineering Manual page 109

1MRK 511 398-UEN C
670 series 2.2 IEC
Engineering manual
Creating a complete HMI display page
Procedure:
1. Make a sketch how to present the single line diagram.
2. Place the apparatus, transformer and other symbols that are needed for the
single line diagram into the raster boxes.
3. Add connection points where needed.
4. Link the apparatus symbols with line elements.
5. Adjust the text symbols while writing to north, east, south or west. Use the
object property window to do it.
6. Place measurements when needed.
7. Edit the name, unit and number of decimals of the measurements.
8. Select each object that has a dynamic link and do the link to the corresponding
process object, see Figure 62.
9. Check to select the correct function block. Function blocks of the same type
can have different instance numbers.
10. Validate that all links are done. Unlinked objects are greyed out.
11. Save the complete picture.
12. Repeat the steps for all pages when more than one is needed.
13. Write the display configuration to IED from the GDE tool.
IEC09000666 V3 EN-US
Figure 62: GDE: Establish a dynamic object link
Linking process objects
To describe a process object within an IED it needs to be established in the
application configuration, configured when given with its parameters by PST and
linked to be displayed in the HMI.
Three tools are involved for the described steps:
• ACT to program the application function block for apparatus and/or
measurements.
• PST to adapt the settings and/or configuration parameter of the application
function block.
• GDE to establish the link for updating the selected data attribute in the HMI of
the application function block.
The following application function blocks are used to deliver the needed
information:
Section 7
Local HMI engineering
IEC09000666-3-en.vsd
103