DS41
2.2
GUIDE TO INSTALLATION
The following can be used as a checklist to verify all of the steps necessary
for complete installation of the DS41 scanner.
1) Read all information in the section "Safety Precautions" at the
beginning of this manual.
2) Open the scanner to select the main serial interface type as required
(see paragraphs 2.3 and 2.4).
3) Correctly position and mount the scanner for barcode reading
according to the information in paragraphs 2.5, 2.8 and 3.4.
4) Provide correct system cabling according to the signals necessary
(see the applicable sub-paragraphs under 2.6 or 2.7).
5) Configure the software parameters from a host computer using
either the WINHOST interface utility program provided on diskette, or
using the Host Mode programming procedure, by ESC sequences
via the serial interface.
For more details about these configuration methods refer to the
section "DS41 Configuration" in the WINHOST Help On Line.
The installation is now complete.
2.2 - Installation
Fine tuning of the scanner position for
barcode reading can be accomplished using
the Test Mode. For further details refer to the
section "Test Mode" in the WINHOST Help
On Line.
NOTE
DATALOGIC