Table of Contents
Advertisement
Installation
Connect the scanner to the host (terminal) using the interface (I/
F) cable as shown below. A cable from an older existing installa-
tion can be re-used for RS-232 interfaces. If external power is
used/needed, plug the AC Adapter into the AC wall outlet, then
connect it to the unit as shown in 'b' of the illustration.
Scan some known-good bar code samples to verify correct oper-
ation. The scanner should beep and/or flash its good read LED
and send the bar code data to the host or terminal. If not, use the
Troubleshooting section of this guide to identify any problems.
a
a
b
b
1. Beeper and LED behavior may have previously been configured as "dis-
abled" by another user.
Quick Reference Guide
USB+Power
Power Off the
Terminal (POT)
RS-232
and USB Cables
Powered by AC Adapter
To Terminal (PC)
Terminal (PC)
1
3
Advertisement
Table of Contents
