Table of Contents
Advertisement
DATALOGIC
Electrical connection is provided through a cable on the side of the reader;
this cable is terminated with a 25-pin connector (25-pin connector models,
see paragraph 1.3, Figure A,
see paragraph 1.3, Figure B,
The laser beam output window is on the right hand side of the scanner
(Figure A,
). A green LED on the same side indicates the laser is active
10
(Figure A,
).
9
A security system allows the laser to activate only once the motor has
reached the correct rotational speed; consequently the laser beam is
generated after a slight delay from the power on of the scanner.
The four LEDs on the left hand side of the scanner indicate the following:
POWER ON
GOOD READ
EXT TRIG
TX DATA
The screw holes on the body of the reader are for mechanical fixture (Figure
A,
); the screw holes shown in Figure A,
2
as the optional 90° mirror.
1
1
LED (red) (Figure A,
the power supply.
LED (red) (Figure A,
decoding. It is also used in Test mode to signal the decoding
percentage (for details refer to the section "Test Mode" in the
WINHOST Help On Line).
LED (yellow) (Figure A,
sensor is active (for details refer to the section "On Line
Mode" in the WINHOST Help On Line).
LED (green) (Figure A,
the main serial output line.
) or by a junction box (junction box models,
).
) indicates the reader is connected to
3
) is used to signal successful barcode
4
) indicates the code presence
5
) indicates data transmission on
6
are to attach accessories such
11
DS41
General features - 1.3
Advertisement
Table of Contents
