Table of Contents
Advertisement
3
Installation of options
3.1
Installation of the silver ionization (for PH15/PH15A only)
Scope of delivery silver ionization kit (Art.-No: 2526530)
–
2 pcs. ionization rods with holder, washer and nuts
–
Connecting cable
–
2 pcs. mounting brackets
Installation
1. Set the PH15/PH15A out of operation and disconnect it from the mains (unplug the mains cable).
On units PH15A additionally close the water supply and disconnect the supply line from the
connection of the unit.
2. Remove water carrier/blanking cover.
3. Press the locking mechanism of the unit housing on both sides inward, then lift the housing
carefully upward from the mobile base.
A
4. Pull float protection cover "A" on both sides apart and remove protection cover forward.
5. Undo four screws of the float mounting support "B" . Then, mount the mounting brackets "C"
and "D" (mounting bracket with the shorter branch "C" on the left) between the side panel and
float mounting support and fix it again with the four screws.
Note: The float switches must not be removed.
6. Fix ionisation rod holders to the mounting brackets with a M6 nut as shown above.
C
B
D
17
Advertisement
Table of Contents
