Quick Start - Analog Devices UG-061 User Manual

Evaluation Board User Guide

QUICK START

The flowchart shown in Figure 3 outlines the initial steps to set
up the evaluation board and associated communication circui-
try. Step-by-step instructions on how to perform each step in
this flowchart are provided in the following sections of this user
guide. When the procedures in Figure 3 have been followed and
the evaluation board is operational, the energy metering IC can
be evaluated using the accompanying LabVIEW evaluation
software.
STEP 1: INSTALL THE DRIVERS.
REFER TO THE INSTALLING
THE DRIVERS SECTION.
STEP 2: POWER THE EVALUATION BOARD.
REFER TO THE CONNECTING THE
EVALUATION BOARD SECTION.
STEP 3: RUN THE EVALUATION SOFTWARE.
REFER TO THE EVALUATION BOARD
SOFTWARE SECTION.
SET UP
COMPLETE
Figure 3. Quick Start Flow Diagram
Rev. 0 | Page 5 of
UG-061