Disposal And Recycling - AUMA SAREx 07.2 – SAREx 16.2 Operation Instructions Manual

Servicing and maintenance
Notes regarding the
maintenance
11.4.

Disposal and recycling

42
We recommend exchanging the seals when changing the grease.
No additional lubrication of the gear housing is required during operation.
Check actuator visually. Ensure that no outside damage or changes are visible.
The electric connection cables must be without damage and wired correctly.
Do a thorough touch-up of possible damage to paint finish to prevent corrosion.
Original paint in small quantities can be supplied by AUMA.
Cable entries, cable glands, plugs etc. have to be checked for correct tightness
and sealing. Consider torques according to manufacturer's details. If required,
replace the components. Only use components which have an EC type exam-
ination certificate.
Check whether Ex connections are fastened correctly.
Take care of possible discolouration of the terminals and wires. This would in-
dicate an increased temperature.
For Ex housings, pay special attention to a possible collection of water. This
may originate from "breathing" due to severe temperature variations (e. g.
change of night and day), from damaged seals etc. Remove any water immedi-
ately.
Check the flame path gaps of flameproof enclosures for dirt and corrosion.
Since the dimensions of all flameproof joints are strictly defined and inspected,
no mechanical work (such as grinding) shall be performed on them. The joint
surfaces have to be cleaned chemically (e. g. with Esso-Varsol).
Prior to fitting, preserve joint surfaces with an acid-free corrosion protection
agent (e. g. Esso Rust-BAN 397).
Ensure that all housing covers are handled carefully and that the seals are
checked.
All cable and motor protection components have to be checked.
If defects impairing the safety are detected during maintenance, repair measures
have to be initiated without delay.
Any kind of surface coating for the joint surfaces is not permitted.
When exchanging parts, seals etc. only original spare parts shall be used.
Our devices have a long lifetime. However, they have to be replaced at one point in
time. The devices have a modular design and may, therefore, easily be separated
and sorted according to materials used, i.e.:
electronic scrap
various metals
plastics
greases and oils
The following generally applies:
Greases and oils are hazardous to water and must not be released into the
environment.
Arrange for controlled waste disposal of the disassembled material or for sep-
arate recycling according to materials.
Observe the national regulations for waste disposal.
SAEx 07.2 SAEx 16.2 / SAREx 07.2 SAREx 16.2