Xantrex Freedom Xi 1000 Owner's Manual page 33

Overload Conditions
There are two kinds of overload conditions:
• an overload warning
• an overload shutdown
Overload Warning When the Freedom Xi's AC load is
approximately 100 W below the overload shutdown limit of
~1000 W (for Freedom Xi 1000 models) or ~2000 W (for Freedom
Xi 2000 models), the audible alarm beeps once every two seconds
and the display screen shows a fault code .
Overload Shutdown When the Freedom Xi's AC load increases
to near ~1100 W (for Freedom Xi 1000 models) and ~2100 W (for
Freedom Xi 2000 models), the audible alarm beeps every second
and the display screen shows a fault code . The Status LED
turns solid RED and in 30 seconds, both the unit and the display
screen will shut down to prevent damage to the inverter and protect
the battery from being over-discharged.
High Surge Loads
Some induction motors used in freezers, pumps, and other motor-
operated equipment require high surge currents to start. The
Freedom Xi may not be able to start some of these motors even
though their rated steady state current draw is within the inverter's
limits. The unit will shut down and indicate an overload shutdown.
975-0754-01-01
Operating During Transition Between Shore Power and Inverter Mode
Over-temperature Conditions
During inverter operation, when the Freedom Xi's internal
temperature starts to approach its preset shutdown limit, the alarm
will beep every two seconds and the display will show fault code
. If the over-temperature condition persists, the alarm will beep
once per second and the display will show fault code . The
Status LED turns solid RED and the inverter will shut down to
prevent damage to the inverter and protect the battery from being
over-discharged. However, when the internal temperature drops and
falls within normal operating temperature, the Freedom Xi will
recover automatically and will continue inverting.
19