Programmed Key - AnyTone AT-D868UV Operating Manual

4. RADIO OVERVIEW
4.2. Programmed Keys
In PC software – Public >> Optional Setting >> Key function, it is possible to set different
functions for [PF1], [PF2],
Function
Voltage
Power
Repeater
Reverse
Digital Encryption
Call
TBST
VOX
VFO/MR
Sub PTT
Scan
FM radio
Alarm
Record switch
Record
SMS
Dial
GPS
Monitor
Main channel switch Choose channel A or channel B as the main channel.
Hot key 1~6
Alone
AT-D868UV Digital DMR & analog transceiver
, keys
Check the current battery capacity voltage
Switch the power between super high, high, middle and low
power.
Switch between talk around and repeater mode.
Turn on/off the frequency reverse function.
Choose the encryption group
In Analog mode, send the DTMF/5TONE/2TONE encode. This
function is only valid for analog channel.
In Analog mode, send the tone press frequency signal to active
the repeater.
Set up the VOX level.
Switch between VFO mode and memory channel mode.
Sub channel PTT, press to start the call on sub channel.
Scan on/off.
FM radio on/off.
Long press the key to start alarm, short press again to exit the
alarm.
Enable/disable the recording function.
Start/stop recording. When stop recording, the radio will remind
repeat or send the record.
In digital mode, press to enter into messages.
Start the manually dial.
Check the GPS position information.
Monitor the weak signal or the signal with unmatched ID.
Press the key to perform the programmed function in hot key
setup.
Turn on/off the work alone function.
Description
15