Installing / Removing The Belt Clip; Installing The Additional Speaker/Microphone (Optional) - AnyTone AT-D868UV Operating Manual
Analog/digital handheld dmr transceiver dual band (vhf/uhf) for amateur radio
Hide thumbs
Also See for AT-D868UV:
- Operating manual (43 pages) ,
- Programming manual (26 pages) ,
- Firmware manual (8 pages)
Table of Contents
Advertisement
3. PREPARATION
3.3. Installing / Removing the Belt Clip
• Installing the Belt Clip: Place the belt clip above the corresponding holes on the
back of the radio, and screw it into place clockwise with the two supplied screws.
• Removing the Belt Clip: Unscrew counter-clockwise to remove the belt clip.
3.4. Installing the Additional Speaker/Microphone (Optional)
• Open the MIC-Headset rubber side cover and then insert the speaker / micropho-
ne connector into the double connector (Kenwood type). It is advisable to have the
transceiver turned off when connecting the micro-loudspeaker or micro-phone or
the programming cable.
When using a headset (optional), avoid high volume levels to avoid possible hearing
damage .
12
AT-D868UV Digital DMR & analog transceiver
Hide quick links:
Advertisement
Table of Contents
