Make A Call; Temporary Monitor - AnyTone AT-D868UV Operating Manual

5. BASIC OPERATIONS
• The left top corner of LCD shows the RSSI icon, and the LED display will show DMR
ID/name/city/state/country/call type and incoming icon based on what is in the
contact list.
• When the call is ended, it will display "Call end", and you can press [PTT] to
respond the call.
5.10. Making a Call
You can choose a target radio via 3 methods:
Method 1: From the Channel switch.
• Turn the channel switch to choose a programmed channel.
Method 2: From the Contact list.
• Turn the channel switch to choose a programmed channel.
• Press key to enter the Contact List, press
Method 3: From the keypad.
• Turn the channel switch to choose a programmed channel.
• Press for main menu.
• Press
• Press
• Input the ID number by keypad, press
ID
Hold the radio vertical 2.5-5cm from your mouth, press the [PTT] key to start the call, the
red LED lights up, the receiver ID/name/city/state/country/call type and call out icon will
be display on the LCD. Release [PTT] key to receive the reply.

5.11. Temporary Monitor

In standby, press and hold the [PF2] key to enter Temporary Monitor. When receiving
matched carrier but the signaling / ID is unmatched or the signal is too weak, this function
allows monitor the weak signal and signal with unmatched ID.
Release the [PF2] key to shut off speaker and return to standby.
In PC software, Public >> Optional Setting >> Other >> Mon Key should be set up to
Squelch Off Momentary.
AT-D868UV Digital DMR & analog transceiver
to Contacts and press Select
to Manual Dial and press Select
key to choose a contact .
key to switch group ID or Private DMR
19