9. MAIN MENU
ANALOG CHANNELS
When the channel type is analog, it will automatically hide the digital menus, the
set of channels will show the analog menus .
The below listed menus are for analog channel only, other not listed menus are same as
the digital channel.
TCDT
Set up the CTCSS/DCS code for TX.
RCDT
Set up the CTCSS/DCS code for RX.
RTCDT
Set up the CTCSS/DCS code for both TX and RX.
• CTCSS code: 62.5Hz~254.1Hz, a total of 51 groups
• DCS code: 000N~7771, a total of 1024 groups
Optional Signal
Allows the set up of DTMF/5TONE/2TONE encode and decode for the analog channels.
Squelch Mode
When the analog channel is set up for both CTCSS/DCS decoding and optional signaling,
you can set up the RX condition in this menu.
• SQ: You can hear the call once the channel receive matched carrier.
• CDT: You can hear the call when the channel receive matched CTCSS / DCS signal
• TONE: You can hear the call when the channel receives a matched signaling.
• C&T: You can hear the call when the channel receives a matched CTCSS/DCS and
matched signaling.
• C|T: You can hear the call when the channel receives a matched CTCSS/DCS or
matched signaling.
Band Width
Select Wide Band or Narrow Band for the analog channel.
Reverse
When this function is enabled, the RX frequency, TX frequency and CTCSS/DCS
encode/decode will be reversed.
AT-D868UV Digital DMR & analog transceiver
33