Getting Started; Overview; Connecting To The Web Server - Honeywell NetAXS-123 User Manual

Getting Started

Overview

The NetAXS-123 is a modular 1-, 2- or 3-Door access control system. A NetAXS-123 access
control site is configured with a host system and access control units that exceed existing
N-1000-III/IV specifications and approvals. These units also communicate with each other
and with a variety of input and output devices. Each access control unit, or panel, has up to
three reader ports. Each port can support two readers. For supported configurations, see
Firmware Compatibility on page
You can communicate with the NetAXS-123 access control unit either through a host
software system or by connecting to the web server through an Ethernet or USB
connection. This chapter describes how to connect to the web server.
For hardware and wiring installation instructions, please see the Installation Guide
supplied. The NetAXS-123 is designed to work with most operating systems and browsers,
but Honeywell recommends Chrome™ for the best performance.

Connecting to the Web Server

The NetAXS-123 embedded web server is intended for supplementary and programming
purposes only. It has not been evaluated by UL for use as a monitoring station.
The embedded web server can be accessed through the following three connection types:
•
•
•
USB
Ethernet through a direct connection
Ethernet through a hub/LAN connection
Note The panel that you are connecting to the computer is the Primary panel. DIP
switch 6 on a Primary panel must be set to ON for a successful connection.
111.
| 5
1
800-05168V5 - A - 02/2018