Getting Started; Overview; Connecting To The Web Server - Honeywell MPA1 User Manual

Getting Started

Overview

The MPA1 is a modular 1 Door access control system. An MPA1 access control site is
configured with a host system and access control units that exceed existing NetAXS-123
specifications and approvals. These units also communicate with each other. Each access
control unit, or panel, has one reader port, which can support up to two OSDP readers. For
supported configurations, see
You can communicate with the MPA1 access control unit either through a host software
system or by connecting to the web server through an Ethernet connection. This chapter
describes how to connect to the web server.
For hardware and wiring installation instructions, please see the Installation Guide
supplied. The MPA1 is designed to work with most operating systems and browsers, but
Honeywell recommends Chrome™ for the best performance.

Connecting to the Web Server

The MPA1 embedded web server is intended for supplementary and programming
purposes only. It has not been evaluated by UL for use as a monitoring station.
The embedded web server can be accessed through the following two connection types:
•
•
Note All information in this document (descriptions, technical specifications,
pictures, illustrations etc) are indicative only, not binding and can be
changed without notice. Nevertheless, this document remains valid.
Ethernet through a direct connection
Ethernet through a hub/LAN connection
Firmware Compatibility on page
Document 800-26311_ A - April 2020
| 5
1
105.