Removing The Chassis Cover - DFI VP101-BT Installation Manual

Removing the Chassis Cover

Please observe the following guidelines and follow the procedure to open the system.
1. Make sure the system and all other peripheral devices connected to it have
been powered off.
2. Disconnect all power cords and cables.
3. The 12 mounting screws on the bottom and two sides of the system are used
to secure the cover to the chassis. Remove these screws and then put them in
a safe place for later use.
4. After removing the mounting screws, lift the bottom side of the chassis
cover to open the system. The Mini PCIe and the micro SD slots will be
readily accessible.
Chassis screw
3
Mini PCIe slots
Power board
Mini PCIe slots
micro SD