Related Manuals for DFI VP070-M8M
Summary of Contents for DFI VP070-M8M
- Page 1 Quick Installation Guide VP070-M8M ARM-Based In-vehicle Fanless Touch Panel PC www.dfi.com Package Contents 1 x VP070-M8M System Unit 1 Switch Cable 12 Rubber Holders 1 ADDM UL Battery Addendum © May 08, 2023 DFI Inc.
-
Page 2: Product Overview
Product Overview Bottom View USB 3.1 Gen1 Power Input Status LED Reset Switch Quick Installation Guide | VP070-M8M... - Page 3 Back View CANbus Quick Installation Guide | VP070-M8M...
-
Page 4: Removing The Chassis Cover
The 8 screws of the system are used to secure the cover to the chassis. Remove the screws and put them in a safe place for later use. Step 2: Slide the cover to open the system. Quick Installation Guide | VP070-M8M... - Page 5 Step 3: The boards can be easily accessed after the chassis cover is removed. System Board Power Board Quick Installation Guide | VP070-M8M...
-
Page 6: Installing An M.2 Card
Installing an M.2 Card M.2 Sockets Quick Installation Guide | VP070-M8M... - Page 7 Screw tight the card onto the stand-off with a screw driver and a stand-off screw until the gap between the card and the stand-off closes up. The card should be lying parallel to the board when it’s correctly mounted. Quick Installation Guide | VP070-M8M...
-
Page 8: Installing An Antenna
Connect the internal cable to the board's antenna connector, screw the antenna connector through the antenna hole with washers and nuts, and screw on the antenna as illustrated below. Antenna Chassis Wall Module Connector Cable Antenna Connector Washer Quick Installation Guide | VP070-M8M... -
Page 9: System Layout
Power Board Power Board ST-Link / SWD MCU Debug Remote Switch Remote Switch High/Low Active 12V DC Out 9V~36V In Host Bus Communication Host Bus Communication LED1(Red): Debug LED for the MCU LED2 (Green): R/W LED Quick Installation Guide | VP070-M8M... - Page 10 System Board System Board USB2_4 HDMI Speaker M.2 B key USB2_3 Battery M.2 E key VP IO Power Link COM1 Debug SIM Slot Boot CFG LVDS USB3.0 DC-IN LED Backlight Audio Quick Installation Guide | VP070-M8M...
- Page 11 System Board - uSD Card Slot System Board uSD Card Slot Quick Installation Guide | VP070-M8M...
-
Page 12: Jumper Settings
Power On Delay Time Select (Delay Duration) 10 seconds (default) 4 On , 5 On 30 seconds 4 Off , 5 On 1 miniute 4 On , 5 Off 5 minutes 4 Off , 5 Off Quick Installation Guide | VP070-M8M... - Page 13 5-6 On Backlight Power 5V 4-6 On DFI reserves the right to change the specifications at any time prior to the product's release. This QR may be based on the product’s revision. For more documentation and drivers, please visit the download page at www.dfi.com/...