Table of Contents
Advertisement
Pivoting
If the pivot function is selected, the machine stops
with the needle lowered (in the fabric) and the
presser foot is automatically raised to an
appropriate height when the "Start/Stop" button is
pressed. When the "Start/Stop" button is pressed
again, the presser foot is automatically lowered
and sewing continues. This function is useful for
stopping the machine to rotate the fabric.
CAUTION
• When the pivot setting is selected, the
machine starts when the "Start/Stop" button is
pressed or the foot controller is pressed down
even if the presser foot has been raised. Be
sure to keep your hands and other items away
from the needle, otherwise injuries may occur.
Memo
• When the pivot setting is selected, the
height of the presser foot when sewing is
stopped can be changed according to the
type of fabric being sewn. Press
display "Pivoting Height" of the settings
screen. Touch the number to select the
height. To raise the presser foot further,
increase the setting. (Normally, 3.2 mm is
set.)
Note
• The pivot function can only be used with
stitches where presser foot "J", "N" or "X"
(Couching foot) is indicated in the upper-left
corner of the screen. If any other stitch is
selected,
not available.
• If the pivot function is selected, "Presser
Foot Height" in the settings screen are not
available and the setting cannot be
changed.
a
Select a stitch.
b
Press
to
The key appears as
Note
• To use the pivot function, the needle
position should be set to
needle position is set to
foot is raised automatically.
c
Place the fabric under the presser foot with
the needle at the starting point of the
stitching, and then press the "Start/Stop"
button. The machine will begin sewing.
USEFUL FUNCTIONS
appears as light gray and is
to select the pivot setting.
.
. When the
, the presser
2
89
Advertisement
Table of Contents
