Table of Contents
Advertisement
LOWER THREADING
h
Pass the end of the thread through the guide
slit in the bobbin winder seat, and pull the
thread to the right to cut the thread with
the cutter.
a Guide slit (with built-in cutter)
b Bobbin winder seat
CAUTION
• Be sure to follow the process described. If the
thread is not cut with the cutter, and the
bobbin is wound, when the thread runs low it
may tangle around the bobbin and cause the
needle to break.
i
Set the bobbin winding switch to the left,
until it clicks into place.
a Bobbin winding switch
Memo
• Sliding the bobbin winding switch to the left
switches the machine into bobbin winding
mode.
• Use the bobbin winding slider to adjust the
amount of thread wound onto the bobbin to
one of five levels.
a Bobbin winding slider
b More
c Less
The bobbin winding window appears.
54
a
Note
• When winding transparent nylon thread on
the bobbin, stop bobbin winding when the
bobbin is 1/2 to 2/3 full. If the bobbin was
fully wound with transparent nylon thread, it
may not be wound neatly.
j
Press
.
Bobbin winding starts. The bobbin stops rotating
when bobbin winding is completed. The bobbin
winding switch will automatically return to its
original position.
Note
•
changes to
winding.
• Stay near the machine while winding the
bobbin to make sure the bobbin thread is
being wound correctly. If the bobbin thread
is wound incorrectly, press
immediately to stop the bobbin winding.
• The sound of winding the bobbin with stiff
thread, such as nylon thread for quilting,
may be different from the one produced
when winding normal thread; however, this
is not a sign of a malfunction.
while the bobbin is
Advertisement
Table of Contents
