Table of Contents
Advertisement
SEWING THE STITCHES
d
Position the fork on the side cutter's
operating lever onto the needle clamp
screw.
a Needle clamp screw
b Operating lever
Memo
• Make sure that the fork of the operating
lever is set onto the needle screw firmly.
e
Position the side cutter so that the side
cutter pin is aligned with the notch in the
presser foot holder, and then lower the
presser foot.
a Notch in presser foot holder
b Pin
The side cutter is attached.
f
Raise the presser foot and pull out a long
section of the upper thread. Pass it below
the presser foot and pull it out in the fabric
feed direction.
a Presser foot
b Upper thread
120
g
Make a cut of approximately 20 mm
(approx. 3/4 inch) in the fabric.
a 20 mm (approx. 3/4 inch)
h
Position the fabric so that the right side of
the cut is on top of the guide plate and the
left side of the cut is underneath the presser
foot.
a Guide plate (lower knife)
b Presser foot
c Upper thread
Memo
• If the fabric is not positioned correctly, the
fabric will not be cut.
i
Lower the presser foot and start.
A seam allowance is cut while the stitching is sewn.
Advertisement
Table of Contents
