Names Of Machine Parts And Their Functions; Machine - Brother 882-W30 Operation Manuals

NAMES OF MACHINE PARTS AND THEIR FUNCTIONS

NAMES OF MACHINE PARTS AND THEIR FUNCTIONS
The names of the various parts of the machine and their functions are described below. Before using the
machine, carefully read these descriptions to learn the names of the machine parts.

Machine

■ Front View
c
a
q
*
p
o
n
a Top cover
Open the top cover when threading the machine or winding the
bobbin.
CAUTION
• Do not place any object weighing 1 kg or more
on the top cover, otherwise the cover may be
damaged.
b Pretension disk
Pass the thread around the pretension disk when winding the
bobbin thread. (page 52)
c Thread guide for bobbin winding
Pass the thread through this thread guide when winding the
bobbin thread. (page 52)
d Spool pin
Place a spool of thread on the spool pin. (page 61)
e Spool cap
Use the spool cap to hold the spool of thread in place.
(page 61)
f Supplemental spool pin
Use this spool pin to wind the bobbin thread, or to sew with the
twin needle. (page 52, 64)
g Bobbin winder
Use the bobbin winder when winding the bobbin. (page 52)
h Bobbin winding slider
Adjust the amount of thread wound onto the bobbin. (page 54)
i LCD (liquid crystal display)
Settings for the selected stitch and error messages appear in
the LCD. (page 28)
j Speaker
k Knee lifter
Use the knee lifter to raise and lower the presser foot. (page 90)
l Knee lifter slot
Insert the knee lifter into the slot. (page 90)
m Operation buttons (7 buttons) and sewing speed
controller
Use these buttons and the slide to operate the machine.
(page 15)
n Needle plate lever
Slide the lever toward you to remove the needle plate.
(page 198)
12
e f
g
h
i
j
l
m
k
o Flat bed attachment with accessory compartment
Store presser feet and bobbins in the accessory compartment
of the flat bed attachment. When sewing cylindrical pieces,
remove the flat bed attachment. (page 16)
p Thread cutter
Pass the threads through the thread cutter to cut them.
(page 63)
q Thread guide plate
Pass the thread around the thread guide plate when threading
upper thread. (page 61)
* Camera and projector (built-in)
CAUTION
• Do not touch the camera or projector.
Otherwise, it will not display properly.
■ Right-side/Rear View
l
k
j
i
h
g
f
a Connector for the presser foot
Connect the dual feed foot or embroidery foot with LED pointer
(sold separately). (page 74)
b Handle
Carry the machine by its handle when transporting the
machine.
c Presser foot lever
Raise and lower the presser foot lever to raise and lower the
presser foot. (page 72)
d Air vent
The air vent allows the air surrounding the motor to circulate.
Do not cover the air vent while the machine is being used.
e Main power switch
Use the main power switch to turn the machine ON and OFF.
(page 26)
f Foot controller
Use the foot controller to operate the machine.
g Power cord receptacle
Insert the power cord into the machine receptacle. (page 26)
h Dual purpose stylus holder connector
Connect the included dual purpose stylus holder. (page 95)
i Foot controller jack
Insert the foot controller plug into its jack on the machine.
(page 78)
a
c
e