Operating Your Stove; Before Operating Your Stove; Blower Operation; The First Fires - Enerzone Harmony 2.3 Installation And Operation Manual

4. Operating Your Stove

4.1 Before Operating Your Stove

Before using the stove, the following items should be installed :
• The door overlay (see
• The optional fresh air intake kit (see
44
• The optional blower (See
• The optional refractory slabs (See
46«) .

4.2 Blower Operation

Figure 7: Air flow with a blower
The blower has a rheostat that can be adjusted in three different
positions; either from high (HI) to low (LO) or closed (OFF).
Allow the stove to reach operating temperature (approximately
one hour) before turning on the blower, since increased airflow
from the blower will remove heat and affect the start up
combustion efficiency.
The blower is also equipped with a heat sensor. When the
blower is ON, it will start automatically when the stove is hot
enough and it will stop when the stove has cooled down.
Therefore, the blower speed control can be left at the desired
setting.

4.3 The First Fires

Two things will happen when burning the first few fires; the paint cures and the internal
components of the stove are conditioned.
Page 16
«Appendix 1. Door Overlay Installation»,
«Appendix 2. Optional Fresh Air Intake Kit
«Appendix 3. Optional Blower and Thermodisc
«Appendix 4. Optional Refractory Panels
It is possible to install a blower on this stove. The blower is
optional and is sold separatly. See
Diagram and Parts
The blower is installed on the back of the stove to increase
airflow through the heat exchanger and improve hot air
circulation in the room. When used regularly, the blower can
provide a small increase in efficiency, up to 2%. However,
the use of a blower should not be used as a way to gain
more output from a stove that is undersized for the space
it is intended to heat.
page 43 ),
List» for genuine part number.
Ensure the blower cord is not in contact
with any surface of the stove to prevent
electrical shock or fire damage. Do not run
cord beneath the stove.
OFF
Figure 8: Blower rheostat
Installation and Operation Manual - Harmony 2.3
Installation», page
Installation», page 45)
Installation», page
«Appendix 6. Exploded
HI
LO