Enerzone Harmony 2.3 Installation And Operation Manual page 24

Remove the door and place it face-down on something soft like a cushion of rags or a piece
of carpet. Remove the old gasket from the door by pulling and prying it out with an old screw
driver. Then use the screwdriver to scrape the old gasket adhesive from the door gasket groove.
Apply a bead of approximately ¼" (6 mm) of high temperature silicone in the door gasket groove.
Starting from the middle, hinges side, press the gasket into the groove. The gasket must not be
stretched during installation. Leave about ½" long of gasket when cutting and press the end into
the groove. Tuck any loose fibers under the gasket and into the silicone. Close the door. Do not
use the stove for 24 hours.
5.1.4 Replacing the Glass or the Glass Gasket
To remove or replace the glass (D), remove the
eight screws (A), the eight glass retainers (B),
and the metal frames (C). Remove the glass.
If it is damaged install a new one in place.
The replacement glass must have a gasket all
around (see procedure below). Reinstall the
glass, being careful to centre the glass in the
door and not to over-tightening the retaining
screw.
The two main causes of broken door glass
are uneven placement in the door and over-
tightening the retaining screws.
Do not abuse the glass door by striking or slamming shut.
Do not use the stove if the glass is broken.
5.1.5 Cleaning and Painting the Stove
Painted and plated surfaces can be wiped down with a soft, damp cloth. If the paint is scratched
or damaged, it is possible to repaint the stove with a heat-resistant paint. Do not clean or
paint the stove when it is hot. Before painting, the surface should be sanded lightly with
sandpaper and then wiped off to remove dust. Apply two thin layers of paint. For best results,
use the original paint, available in aerosol cans.
Page 24
It is a good idea to replace the glass gasket when the door gasket is
replaced. Follow the previous steps to remove the glass. Remove the old
gasket and clean the glass thoroughly. The new gasket is flat, adhesive-
backed, woven fibreglass. The gasket must be centred on the edge of
the glass. To do this easily, peel back a section of the paper covering
the adhesive and place the gasket on a table with the adhesive side up.
Stick the end of the gasket to the middle of one edge, then press the
edge of the glass down onto the gasket, taking care that it is perfectly
centred on the gasket. Peel off more of the backing and rotate the glass.
The gasket must not be stretched during installation. Cut the gasket to
the required length. Pinch the gasket onto the glass in a U-shape, all
around the glass.
C
D
E
Figure 13: Replacing the glass
Installation and Operation Manual - Harmony 2.3
A
B