S5 Unilink Adapter Dipswitch Location - Siemens SIMATIC TI505 Installation And Operation Manual

2.3 Setting the Dipswitches
Dipswitch Location
Dipswitch 1
Dipswitch 2
2-6 Installation and Set-up
Two banks of dipswitches are provided on the S5 UniLink CPU board,
accessible by opening the cover plate on the face of the unit (see Figure 2-4).
S5 PIM
Dipswitch 1
Figure 2-4 S5 UniLink Adapter Dipswitch Location
Dipswitch 1 is used to configure the S5 Interface Port and the TIWAY
network port, as shown in Figure 2-5.
The data rate of the S5 UniLink Adapter interface port can be set for either
9600 or 19,200 baud using switch 3 on Dipswitch 1 (see Figure 2-5). The
remaining communications parameters are fixed as follows: 8 data bits,
even parity, and 1 stop bit. Be sure to program the attached CP 525 module
to accept the S5 UniLink Adapter's communication parameters.
NOTE: Set switches 1 and 2 to correspond to the CPU number with which
you want the S5 UniLink Adapter to communicate. Refer to the CP 525
manuals for more information about the CPU number.
Dipswitch 2 is used primarily to configure the secondary address of the
S5 UniLink Adapter (see Figure 2-6). Refer to your UNILINK Adapter
Installation and Operation Manual for dipswitch settings.
Dipswitch 2
S5 UniLink Adapter Installation and Operation
A000653a
I003643