Siemens SIMATIC TI505 Installation And Operation Manual page 20

S5 unlink adapter

Hide thumbs Also See for SIMATIC TI505:

Table of Contents

Programming the

CP 525

S5 UniLink Adapter Installation and Operation

For the S5 UniLink Adapter to establish communications with the CP 525

module, the following prerequisites must be met. Use the PG programmer to

load these parameters.

•

The STEP 5 user program in the CPU must include the data handling

blocks

SEND ALL

•

The CP 525 user program of the CP module must include the RK 512

Interpreter and the 3964R Transfer Procedure.

NOTE: Remember to program the communications parameters (9600 or

19,200 baud, 8 bits, even parity, and 1 stop bit) in the CP 525 module.

No jobs in the CP module job block are required for the connection to the

S5 UniLink Adapter.

For more information on setting up the CP 525 module and the controller

CPU, refer to the CP 525 Communications Processor manuals.

and

RECEIVE ALL

Installation and Set-up

2-3

Table of Contents