Changing The Jumper Settings - Mitsubishi Electric apricot MS660 Owner's Handbook Manual

S y s t e m m o t h e r b o a r d

Changing the Jumper settings

PL32
PL37
PL36
8/2 MS660 OWNER'S HANDBOOK
Caution Caution
Do not alter any jumper settings under normal operation. You may
cause permanent damage to the motherboard or its components.
All jumpers are factory set and should not normally be changed.
'1-2' = jumpers should be fitted across pins 1 and 2.
'2-3' = jumpers should be fitted across pins 2 and 3, etc.
'Open' or 'O' = no jumpers should be fitted.
'Closed' or 'X' = jumpers should be fitted
On the motherboard, pin 1 of each block is indicated by a small
triangle marking.
PL100
PL22
PL11
PL10
PL8
PL3, PL4, PL6,
& PL7
PL2