Entering Setup; Setup Runs On Its Own - Mitsubishi Electric apricot MS660 Owner's Handbook Manual

S y s t e m B I O S a n d S e t u p

Entering Setup

If Setup runs on its own
9/2 MS660 OWNER'S HANDBOOK
Immediately after switching on the Mitsubishi logo is displayed at
the top right hand corner of the screen:
While this is visible you can press the F1 key to start the BIOS
Setup utility.
You cannot enter the BIOS setup at any other time or by any other
method.
This can happen for three reasons:
♦
POST detects a configuration error or fault. This may be
signalled by one or more of the POST error messages listed at
the end of this chapter. If a persistent fault is indicated, make a
note of any new error messages and the current configuration
settings before calling an authorised maintainer.
♦
The CMOS battery may be running down. This may be
signalled by spurious POST error messages. If this happens
every time you turn on the computer, you may have to change
the battery, instructions for this are given in the chapter:
'System motherboard'.
♦
The computer's configuration may have been changed, for
example by the addition of more system memory, or an
expansion card. In this case you may have to define the new
configuration.