AEG CCS6741ACM User Manual page 28

28 www.aeg.com
Problem
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The display shows "12.00".
Steam and condensation
settle on the food and in the
cavity of the oven.
There is no good cooking
performance using the True
Fan Cooking PLUS function.
The water in the cavity em-
bossment does not boil.
The water comes out of the
cavity embossment.
12.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)
Possible cause
The oven is deactivated.
The clock is not set.
The necessary settings are
not set.
The lamp is defective.
There was a power cut.
You left the dish in the oven
for too long.
You did not fill the cavity
embossment with water.
The temperature is too low.
There is to much water in the
cavity embossment.
on the front frame of the oven cavity. Do
not remove the rating plate from the
oven cavity.
.........................................
.........................................
.........................................
Remedy
Activate the oven.
Set the clock.
Make sure that the settings
are correct.
Replace the lamp.
Reset the clock.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Refer to "Activating the True
Fan Cooking PLUS func-
tion".
Set the temperature at least
to 110°C. Refer to "Hints
and Tips" chapter.
Deactivate the oven and
make sure that the appliance
is cold. Wipe the water with
a cloth or sponge. Add the
correct amount of water to
the cavity embossment. Re-
fer to "Activating the True
Fan Cooking PLUS func-
tion".