Tips For Remote Control And Foot Switch; Method For Using Cutter; Cross Cutter - Royal Sovereign RSS-1050 Owner's Manual

TIPS FOR REMOTE CONTROL AND FOOT SWITCH

1. It is convenient to use the remote control in the back of machine while laminating.
2. It is also convenient if you use Foot Switch while laminating HARD BOARD.
3. "RUN", "STOP", "REV" buttons on Remote Control have same functions
with the ones on Control Panel.
4. Press Foot Switch one time for "RUN", press one more time for "STOP".
(Don't keep pressing)
5. After use of Remote Control, attach it to the left side of rear of machine.

METHOD FOR USING CUTTER

1.Cross Cutter

1. It is on the back side of the machine.
2. After lamination, move cutter to a point about
1/3 of the width of lamination.
3. Grasp film with one hand and press the cutter
downward and slide it to the direction
intending to cut with another hand.
4.Press the cutter and slide it the other way.
- 22 -