Royal Sovereign RSS-1050 Owner's Manual page 19

1. It would be easier for you to operate the machine next time if the tempreature and
the speed are set at the best condition and memorized by using the
2. sign may appear on LCD window in the case continuous laminating.
If it happens, the speed needs to be lowered by one speed level and started again
after signal on the LCD window.
3. In case of wrinkling or rolling of film due to wrong position of document, the button
of is needed to be keeping pushed in order that document could come out
REV
to the front with buzzer sound.
4. When document is much smaller than film, you should place it in the middle of film
for preventing wrinkle.
5. Use cooling fan when you laminate continuously without break and document is too hot.
***Laminating Speed at each level***
SPEED 1
SPEED 2
SPEED 3
SPEED 4
SPEED 5
SPEED 6
SPEED 7
SPEED 8
SPEED 9
The above laminating speed numbers are at the condition on regular voltage with
almost no film tension. There might be the possibility for difference to the above
numbers due to the change of voltage or adjustment of tension.
***Useful Information***
1.0m(3.3ft)
1.6m(5.2ft)
2.0m(6.6ft)
2.2m(7.2ft)
2.6m(8.5ft)
3.3m(10.8ft)
4.3m(14.1ft)
5.2m(17.1ft)
6.0m(19.7ft)
- 19 -
button
MEMORY