Peripheral Devices - Omron CS1W-CRM21 Operation Manual

Devices in a CompoNet Network
1-3-2

Peripheral Devices

Communications Cables
Name
Round Cable I
Round Cable II
Flat Cable I
Flat Cable II
Flat Connectors
Flat Connector Socket
Name Model
Flat Connector DCN4-TR4
Socket
14
The following table shows the Communications Cables that can be used in a
CompoNet Network.
Model
--- JIS C 3306
Nominal cross-sectional area: 0.75 mm
Finished conductor diameter: 2.3 mm
DCA4-4F10 Standard 4-conductor flat cable (UL2555)
Length: 100 m
Conductor diameters:
0.75 mm
DCA5-4F10 Sheathed 4-conductor flat cable
Length: 100 m
Conductor diameters:
0.75 mm
In a CompoNet Network, the connectors described below can be connected
to the Communications Cable to enable extending the cable length, branching
cables, and wiring to Slave Units.
■ Flat Cable I
Appearance
Use this Connector in a set with
a DCN4-BR4 Flat Connector
Plug for the following applica-
tions.
• Extending the trunk line or a
• T-branching from the trunk line
• T-branching a sub-branch line
Note The only case when the Socket is used with a Round Cable II is to connect
the Cable to a Terminating Resistor.
Specifications
× 2, 0.5 mm × 2
2 2
× 2, 0.5 mm × 2
2 2
Application
sub-trunk line
or a sub-trunk line
from a branch line
Section 1-3
Remarks
Cannot be used with Bit Slave
Units.
2
,
Approximately 50 cm of cable
comes connected to IP20 Bit
Slave Units.
Approximately 50 cm of cable
comes connected to IP54 Bit
Slave Units.
Communications Cables
(Yes: Can be used.
No: Cannot be used.)
Round Round Flat
Cable I Cable II Cable I
Yes
No (See Yes
note.)
Flat
Cable II
No