Overview Of Operating Procedure - Omron CS1W-CRM21 Operation Manual

Overview of Operating Procedure

1-5 Overview of Operating Procedure
1. Install and wire the system.
Wire the network, the communications power supply, and the I/O power
supply.
2. Select the communications mode number on the front of the Master Unit.
Set the communications mode number to 0, 1, 2, 3, or 8.
3. Make the following settings on the DIP switch on the front of the Master Unit.
SW1 (DR0) and SW2 (DR1): Set the baud rate.
SW3 (ESTP): Set whether communications are to stop when an error
occurs.
SW4 (REGS): Enable or disable the Registration Table.
4. Set the unit number on the front of the Master Unit.
Set a number from 0 to 95.
5. Set the Slave Unit node addresses.
Set a node addresses from 0 to 63 for Word Slave Units and from 0 to
127 for Bit Slave Units.
6. Connect the computer running the CX-Integrator to the PLC where the Master
Unit is mounted.
7. Turn ON the power to the PLC.
8. Using the CX-Integrator, edit and download the Master Unit device parameters.
1. Connect online to the PLC where the Master Unit is mounted.
2. In the Online Connection Information Window, right-click the Master
Unit under the connected PLC, and then select Connect.
3. Right-click the Master Unit under the connected PLC, and select
Transfer [Network to Computer].
4. Double-click the Master Unit in the Network Configuration Window,
and then edit and download the device parameters.
9. Turn OFF the power to the PLC.
10.Remote I/O communications will start when all registered Slave Units are partic-
ipating.
11.Using the CX-Integrator, monitor the participation status of the Slave Units.
1. While online, upload the network configuration.
2. Right-click the Master Unit in the Network Configuration Window and
select Monitor to monitor the participation status on the Status/Unit
Status Tab Page.
20
Follow the steps below to install and use a CompoNet Network.
▼
▼
▼
▼
▼
▼
▼
▼
▼
▼
Section 1-5
... SECTION 4 Installation and
Wiring
...SECTION 2 Master Units
...CX-Integrator Operation
Manual