Converting Jr2000/Jr2000N Data To Jr3000 Data - Janome JR3200 series Operation Manual

9. CONVERTING JR2000/JR2000N DATA TO
To use JR2000/JR2000N series teaching data as JR3000 series C&T data, it is necessary to convert
the data. The following three steps are needed to convert data:
1. Use JR Points (JR2000 optional) and/or JR C-Points (JR2000N optional) to send the data to the
PC.
2. Open the data received from step 1 using JR C-Points II*.
3. Send the data from the PC to the JR3000 using JR C-Points II*.
Connect
JR2000/JR2000N
Example: JR2203N
*In place of JR C-Points II (optional), JR C-Points II Limited Edition (included in the Operation Manual
CD) can also be used to convert data.
NOTE
It is possible to connect one PC to both a JR2000/JR2000N Series robot and a JR3000 Series
robot at the same time. You can also connect a PC to the JR2000/JR2000N Series robot, receive
the data, disconnect the JR2000/JR2000N robot, and then connect the JR3000 Series robot.
(To convert data using one PC, JR-Points or JR C-Points and JR C-Points II must be installed on
the PC.)
Caution
Setup
JR3000 DATA
Teaching Data
PC(JR-Points/
JR C-Points)
Make sure to turn OFF the robot before removing or connecting
cables. Failure to do so may cause unit malfunction or data loss.
Connect
PC(JR C-Points II)
48
JR3000 Series
Example: JR3203N-AC
Desktop Robot JR3000