Jr C-Points Ii Limited Edition Requirements - Janome JR3200 series Operation Manual

2.6.1 JR C-Points II Limited Edition Requirements

To operate JR C-Points II Limited Edition (included in the Operation Manual CD), the following system
configurations are necessary:
Computer
Memory capacity
OS
Hard disk capacity
LAN (Ethernet)
The required memory capacity and hard disk capacity can vary depending on the PC's system
requirements.
Also, take care when using a PC because if there is not enough free hard disk space, it can result in
insufficient memory during operation or other such problems.
How to install JR C-Points II Limited Edition
1. Startup Windows® and confirm it is operating properly. Also close down any other open
applications.
2. Insert the Operation Manual CD into the CD-ROM drive. In the [JCP*E***L] folder (* =
specifications, *** = version number) double click [¥SETUP.EXE]. The installer starts up.
3. Follow the instructions on the screen and proceed with the installation.
NOTE
If the installer is started up when the software is already installed, it will begin the uninstallation
process. To uninstall JR C-Points II Limited Edition follow the same procedure as above to start up
the uninstaller.
Setup
A PC capable of running Windows® 7/8/8.1
512MB or more
Microsoft Windows® 7/8/8.1
NOTE: compatible with both 32bit/64bit systems.
2 GB or more free disk space after installing Windows® 7/8/8.1
To connect to the robot, a LAN cable with the following
specifications are required:
• Straight cable (CAT5)
The connectable Ethernet specifications (on the PC side) are as
follows:
• 10/100BASE-TX
• LAN Port: RJ-45
29 Desktop Robot JR3000