Lan Cable - Janome JR3200 series Operation Manual

2.6.2 LAN Cable

Attention
Use a straight LAN cable (category 5) compatible with the 10/100BASE-TX standard to connect the
Robot and PC. Insert one end of the LAN cable into the LAN port on the robot and the other into the
LAN port on the PC.
LAN Port
If you are using JR C-Points II (optional) to operate the robot from the PC, please remove the teaching
pendant. You cannot operate the robot with the teaching pendant connected.
You cannot use a teaching pendant with an emergency stop switch (optional) unless a short connector
is connected.
LAN Settings
To get the robot and PC to interface, you need to setup an IP address on both the robot side and PC
side. For further details please refer to "2.6.5 Robot IP Address Settings" and "2.6.6 IP Address
Settings on the PC".
Setup
Make sure power to both the robot and the PC are OFF before attaching or
removing cables. Failure to do so can cause malfunction.
Robot Front (Example: JR3203N-AC)
30 Desktop Robot JR3000