Program Number Switching Method - Janome JR3200 series Operation Manual

MENU [All Program Common Settings]
TP
[Data] [All Program Common Settings]
PC

8.2.3 Program Number Switching Method

If you want to change program numbers by connecting a digit switch to the I/O terminal, select [Load at
Start].
Selection
LOAD/ACK Handshake
Load at Start (I/O-SYS)
Load at Start (Fieldbus)
LOAD/ACK Handshake
Program Number
LOAD Signal
Program Number
1 – 512
Program Number
ACK Signal
NOTE: Program Number 1 – 64 signals are loaded under the default [Program Number Switching
Method] settings. If you wish to use the Program Number 128/256/512 signal, you need to
change the signal function in the [I/O-SYS Function Assignment] settings.
MENU [All Program Common Settings]
TP
[Data] [All Program Common Settings]
PC
Setup
[I/O Settings]
[Program Number Reading Format]
When the Program Number LOAD Signal comes ON, the status of
the I/O Signal Program Number 1 – 512 is loaded (for the Fieldbus,
the status of the program number register is loaded), the Program
Number ACK signal is output, and the program number changes.
When the start instruction is received, the status of the I/O signal
program number 1 – 512 is loaded, and the program number
changes.
When the start instruction is received, the status of the program
number register is loaded, and the program number changes.
LOAD
ACK
Acquire
[I/O Settings]
[Program Number Switching Method]
[Common Data]
Description
Load at Start
Start Signal
Program Number
1 – 512
[Common Data]
46
Acquire
Desktop Robot JR3000