Security Firewall Name <Name> Default-Log <Action - Brocade Communications Systems 5600 vRouter Configuration Manual

security firewall name <name> default-log <action>
Defines an IP firewall rule set to log packets that reach the default action.
Syntax
set security firewall name
delete security firewall name
show security firewall name
Parameters
name
Multi-node. The name of a firewall rule set. The name must not contain a space or any other of the following special
characters: |, ;, &, $, <, or >. The name can be as many as 28 characters long.
You can define more than one firewall rule set by creating more than one name configuration node.
accept
Accept packet if no pior rules are matched.
drop
Drop packet if no prior rules are matched.
Modes
Configuration mode
Configuration Statement
security {
firewall {
name name {
default-log
}
}
}
Usage Guidelines
Use this command to define an IP firewall rule set.
A firewall rule set is a named collection of as many as 9999 packet-filtering rules. Following the configurable rules is an implicit
rule, rule 10000, which denies all traffic.
NOTE
The "deny all" rule stays in effect until every reference to the rule set is removed; that is, until every packet filter that
references the rule set has been removed from all interfaces.
Use the set form of this command to define a firewall rule set.
Use the delete form of this command to delete a firewall rule set.
Use the show form of this command to display a firewall rule set.
54
name default-log { accept | drop }
name default-log [ accept | drop ]
name default-log
action
drop
Firewall Commands
Brocade 5600 vRouter Firewall Configuration Guide
53-1004253-01