Security Firewall Config-Trap <State - Brocade Communications Systems 5600 vRouter Configuration Manual

security firewall config-trap <state>
Enables the generation of Simple Network Message Protocol (SNMP) traps regarding firewall configuration changes.
Syntax
set security firewall config-trap { disable | enable }
delete security firewall config-trap [ disable | enable ]
show security firewall config-trap
Command Default
Disabled.
Parameters
disable
Disables the generation of SNMP traps regarding a firewall configuration change.
enable
Enables the generation of SNMP traps regarding a firewall configuration change.
Modes
Configuration mode
Configuration Statement
security {
firewall {
config-trap
disable
enable
}
}
Usage Guidelines
A device uses SNMP traps to notify, without solicitation, the manager of the device about significant events, such as firewall
configuration changes.
Use the set form of this command to enable the generation of SNMP traps when a firewall configuration change is made.
Use the delete form of this command to restore the default behavior.
Use the show form of this command to display the state regarding the generation of SNMP traps on firewall configuration
changes.
Brocade 5600 vRouter Firewall Configuration Guide
53-1004253-01
Firewall Commands
49